Site Controller Verification; Site Controller Test Equipment; Service Computer Startup; Table 6-1 Test Equipment For Cabinet Testing - Motorola iDEN Site Controller System Manual

Chapter 6 System Testing
Site Controller Verification

Site Controller Test Equipment

Table 6-1 Test equipment for cabinet testing
Equipment
service computer *
T1/E1 test set
T1/E1 test cable
RS-232 cable
communication
software
* Either a DOS-based computer or Macintosh computer may be used for the service computer. Contact your iDEN System
Manager for additional information.

Service Computer Startup

6-4
Table 6-1 lists the recommended test equipment for the site controller. This
test equipment only applies to the site controller testing procedure.
Model/type
80286 or better
Fireberd
n/a
n/a
ProComm Plus (except
version 2.0.1)
(or equivalent)
This procedure assumes that power is applied to the system. If power is not
applied, perform the procedures in the Final Checkout chapter.
Whenever the following procedures instruct you to enter software
commands, this manual presents the commands in bold lettering. Enter all
commands exactly as they appear. The command prompt precedes the
command, as in the following example:
Supplier
®
IBM , IBM local service computer
compatible, or
Macintosh
TTC used to generate a Quasi Random Signal
Sequence (QRSS) bit pattern and
perform a loop-back test
locally procured connects the T1 test set to the customer
maintained T1 circuit
locally procured straight through connecting cable with
DB9 connector for site controller port
DataStorm host communication
Technologies
iSC> whois isc
Gen 3 Site Controller System Manual
Description
68P80801E30-A 5/1/2002