Table 3-7 Punch Block 2 Pin-Outs - Motorola iDEN Site Controller System Manual

Chapter 3 Pre-Installation
Alarm Wiring
3-28
Punch Block 2 – Alarm Connections
The EAS/EAS2 connector and pin label information refers to the connectors
on the EAS/EAS2 itself. Only the alarm code number is passed to the OMC.
Table 3-7 shows those alarms that connect from the User Alarm/Control
connector on the back of the EAS/EAS2 to punch block 2.
Table 3-7 Punch block 2 pin-outs
Alarm Punch block
code pairs
201 6, 31
202 5, 30
203 14, 39
204 13, 38
205 12, 37
206 11, 36
207 10, 35
208 9, 34
209 8, 33
211 7, 32
212 22, 47
213 21, 46
214 20, 45
215 19, 44
216 18, 43
217 17, 42
218 16, 41
252 15, 40
255* 26, 2, 1
256* 28, 4, 3
* These alarms are outputs controlled by the EAS/EAS2 and/or
OMC.
Gen 3 Site Controller System Manual
EAS/EAS2 standard alarm
connection
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined input
customer defined output
customer defined output
68P80801E30-A 5/1/2002