Motorola iDEN Site Controller System Manual page 178

Chapter 8 Software Commands
Site Controller Commands
DISPLAY TEMP
PING STANDBY
SWITCH ISC
8-8
Syntax:
display temp
The command 'display temp' displays the temperature of the site controller
in degrees Centigrade.
Example:
iSC> display temp
GPS Temperature OK at 34 deg C
Syntax:
ping standby
The 'ping standby' command sends a ping message to the standby site
controller. If the standby site controller is alive, it returns a ping response.
This response contains information about its availability.
Example:
iSC> ping standby
Standby iSC is
Standby GPS is
Syntax:
switch isc
The 'switch isc' command forces the standby site controller to become the
active site controller, and the active site controller to become the standby site
controller. This command cannot be executed on the standby site controller.
The standby site controller must be up and running the site controller Install/
Test application.
Gen 3 Site Controller System Manual
available
not available
68P80801E30-A 5/1/2002