Jumper Settings For Controller Board - Motorola M68HC08 Manual

Appendix B — System Set-up
Figure 9-1. Setup of the Application with BLDC Motor

9.3 Jumper Settings for Controller Board

Designer Reference Manual
72
Freescale Semiconductor, Inc.
The jumper settings for the 3-phase BLDC drive board, shown in
9-2. Jumper Reference of BLDC Drive Board
Drive Board Jumper Settings are required to execute the 3-phase
BLDC motor control application controlled by the on-board user
interface.
Jumper J3 enables selection of an external user interface, as well as
microcontroller flash programming using bootloader.
The zero ohms resistors R41 and R42 define the voltage level of power
supply for Hall sensors available on pin 5 of Hall sensor connector J1.
• R41 populated with zero ohms resistor for +12Vdc on J5/1
Appendix B — System Set-up
For More Information On This Product,
Go to: www.freescale.com
Figure
and Table 9-1.BLDC
DRM046 — Rev 0
MOTOROLA