Recommended Test Equipment; Table 3-9 Recommended Test Equipment For Installation - Motorola iDEN Site Controller System Manual

Gen 3 Site Controller System Manual

Recommended Test Equipment

68P80801E30-A 5/1/2002
Table 3-9 lists the recommended test equipment for installation. These are
not included as part of the system shipment and must be procured locally.
All model numbers are Motorola part numbers, unless noted otherwise.
Table 3-9 Recommended test equipment for installation
Test Equipment
communication
software
digital multimeter
(only 1 required)
file compression
software
ground resistance
ohmmeter
RF attenuators
service computer
communication cable
between PC service
computer and the
equipment
communication cable
®
between Macintosh
service computer and
the equipment
service monitor
Recommended Tools, Equipment, and Parts
Model/Type Supplier
Procomm DataStorm
Plus (or
equivalent)
Fluke 77 Fluke
R1037A Motorola
R1073A Motorola
PKUnzip PKWare
AEMC 3700 locally
clamp-on procured
ground tester
refer to the Parts and Suppliers
appendix
refer to the Systems Testing
chapter
n/a n/a
n/a n/a
R2660 w/ Motorola
iDEN
Chapter 3 Pre-Installation
Purpose
host
communication
DC measurements
DC measurements
DC measurements
compress/
decompress large
files
measure for
adequate ground
protection for
R2660 and used
with the
equipment for RF
attenuation
local service
terminal
DB9 male / RS232
male used with
RS232 female /
DB9 male. Pinouts
from DB9 to DB9
must be straight
through
Din 8 male / DB9
male
station alignment
3-33