Table 3-6 Punch Block 1 Pin-Outs - Motorola iDEN Site Controller System Manual

Chapter 3 Pre-Installation
Alarm Wiring
3-26
Punch Block 1 - Alarm Connections
The EAS/EAS2 connector and pin label information refers to the connectors
on the EAS/EAS2 itself. Only the alarm code number is passed to the OMC.
Table 3-6 shows those alarms that connect from the System/Alarm/Control
connector on the back of the EAS/EAS2 to punch block 1.
Table 3-6 Punch block 1 pin-outs
Alarm Punch block
code pairs
210 23, 48
219 7, 32
220 8, 33
221 9, 34
222 10, 35
223 11, 36
224 22, 47
241 21, 46
242 12, 37
243 13, 38
244 14, 39
245 15,40
246 16, 41
247 17, 42
248* 30, 6, 5
249 20, 45
250 19, 44
251 18, 43
253* 26, 2, 1
254* 28, 4, 3
* These alarms are outputs controlled by the EAS/EAS2 and/or OMC.
Gen 3 Site Controller System Manual
EAS/EAS2 standard alarm connection
reserved for system use
predefined input, site entry
predefined input, site high ambient temperature
predefined input, site low ambient temperature
predefined input, site smoke detector
predefined input, site AC surge protector
reserved for system use
reserved for system use
AC Power failure
low DC voltage
high DC voltage
breaker failure alarm
minor rectifier module failure
major rectifier failure
pre-defined output generator remote start
reserved for system use
reserved for system use
reserved for system use
customer defined output
customer defined output
68P80801E30-A 5/1/2002