Table of Contents
Advertisement
CPX-CEC-...
1.5.4
System parameter settings
The system parameter settings for the overall CPX system are configured as follows:
1.
Select the CPX module in the "PLC Configuration" window.
2.
Switch to the "System Parameters" tab.
3.
Change the individual parameter values if required.
Figure: System parameter settings
1.5.5
Rotary switch settings
The complete description for the Festo CoDeSys controller CPX-CEC P.BE-....-... contains
information on rotary switch settings for the CPX-CEC-... (see also CPX-CEC_en.pdf on CD-ROM).
The rotary switch is permanently assigned to a variable in the PLC configuration. The marking in the
configuration area makes this input address available as a global variable (%IB0, %IX0.0 to %IX0.7) so
that all the programs in the controller can access this variable.
The controller is in stop status when the rotary switch is set to 0.
Figure: Display of the rotary switch value in the PLC configuration
26
Advertisement
Table of Contents
