Festo CPX-CEC Series Manual page 30

CPX-CEC-...
Addressing settings
•
Please read the instructions in the CoDeSys basic documentation relating to "Automatic calculation of
addresses" and "Check for overlapping addresses".
Figure: CPX-CEC settings
Options for modifying the "base parameters" of a module:
•
Edit the addresses for the I, O and diagnosis specified automatically by CoDeSys.
•
Enter the address ranges for I, O and diagnosis manually when the "Automatic calculation of
addresses" option is disabled.
Tip for adding a module to an existing project at a later time:
•
Specify the address manually.
This will prevent subsequent module addresses from shifting.
Note
You must assume responsibility for the consequences of specifying address ranges manually and
disabling the option "Check for overlapping addresses".
•
Check the distribution of the address ranges.
Figure: Base parameters when selecting modules
28