Festo CPX-CEC Series Manual page 38

CPX-CEC-...
Parameters
The "Parameters" tab contains information on the connected modules that can be modified in offline
status.
•
Select the CPX module in the "PLC Configuration" window.
•
Switch to the "Parameters" tab.
•
Change the individual parameter values if required.
Note
Parameter changes are only transferred to the controller system and only come into effect after a
download in online mode.
Figure: Parameters
Idle mode
The behaviour of the outputs of a module when the controller switches to stop status and idle mode is
active can be defined on the Idle Mode tab.
Idle mode must be activated under "System parameter settings" before these values can be set.
•
Select the CPX module in the "PLC Configuration" window.
•
Switch to the "Idle Mode" tab.
•
Set the values in the drop-down list boxes in the list.
Figure: Idle mode
36