Settings] [Axis Type]; Settings] [Axis Parameter] - Festo SFC-LAC CO Series Manual

4. The control panel (only type SFC−LAC−...−H2−...)

4.5.1 [Settings] [Axis type]

4.5.2 [Settings] [Axis parameter]

4−14
[Axis type]
[HME−...]
Teach mode for setting the axis parameters
Note the instructions in section 5.2.6 and 5.2.7.
·
[Axis parameter] Description
*)
[Zero point]
*)
[SW−limit−neg]
*)
[SW−limit−pos]
[Tool load]
[SAVE...]
*)
Teaching only possible after successful homing.
Note
A new reference run must always be carried out if the axis
zero point is modified.
The project zero point PZ can only be set via FCT or
PNU 500/CI 21F4 .
h
Parameters
Electric linear module
Select the type used:
e. g. HME−16−100 for an HME of size 16 with
100 mm rated stroke.
Offset axis zero point
Software end position, negative
Software end position, positive
Tool mass, e.g. a gripper on the front panel of
the HME−...
Save parameters in EEPROM
Festo P.BE−SFC−LAC−CO−EN en 0708NH