CPX-CEC-...
1.
Open the desired axis group in the PLC configuration.
2.
Enter the value "8000 µs" for the cycle time/interpolation time.
Figure: PLC configuration
A VirtualBusInterface can be added to the SoftMotion PLC configuration.
Figure: PLC configuration
Note
The controller must be reset after changing the cycle time.
•
Switch the device back on again.
All other instructions can be found in the documentation for SoftMotion in CoDeSys. The document
'CoDeSys_SoftMotion_V23_E.pdf' is stored in the directory: C:\Program Files\Festo\CoDeSys
V2.3\Documents\English\...
34