Jacking Instructions - Toro Reelmaster 5410 Series Service Manual

Jacking Instructions

Raising the Front of the Machine
Safety: Jacking Instructions
Failing to properly support the machine with appropriate jack stands
can cause the machine to move or fall and can result in personal
injury.
When changing the attachments, tires, or performing other services,
do the following steps:
• Use correct blocks, hoists, and jacks to raise and support the
machine.
• Park the machine on a solid level surface, such as a concrete
floor.
• Before you lift the machine, remove all the attachments that may
interfere with the safe and correct lift of the machine.
• Always block the wheels with chocks.
• Use appropriate jack stands to support the raised machine.
• Do not use the cutting deck or implement as a jacking point.
g211752
1. Front jacking point
1. Set the parking brake and block the 2 rear wheels with chocks to prevent
the machine from moving.
2. Position the jack under the rectangular pad on the front axle tube, just to the
inside of the front wheel
3. Use a jack to raise the front of the machine.
4. Position jack stands under the frame as close to the wheel as possible to
support the machine.
CAUTION
Figure 2
2. Front wheel
(Figure 2).
Page 1–6 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C