Jacking Instructions - Toro Greensmaster eTriFlex 3360 Service Manual

Jacking Instructions

g286954
1. Foot step – left front of the machine 2.
Safety: Jacking Instructions
Mechanical or hydraulic jacks may fail to support the machine and
cause a serious injury.
• Use jack stands to support the raised machine.
• Use only mechanical or hydraulic jacks to lift the machine.
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, remove the key from the key switch and unplug the 48V battery
disconnect.
2. Position the jack securely under the desired jacking point:
• Foot step on the left side of the machine
• Jack bracket on the right side of the machine
• Caster fork at the rear of the machine
Jack bracket – right front of the
machine
3. After raising the machine, use an appropriate jack stand at the following
locations to support the machine.
Use two jack stands (one under each battery tray) when supporting
the rear of the machine.
DANGER
Figure 1
3.
IMPORTANT
Page 1–6
Caster fork – rear of the machine
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A