Set The Hdcp Settings; Emulate The Correct Edid - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
4. Installation 4. Installation
4.8.6. Set the HDCP Settings
Check the HDCP settings either on the input and output ports. For more details about the HDCP technology
see the HDCP Management section.
▪ Open the HDMI in 1 and 2 port properties
panel on the transmitter or transceiver side
and check the HDCP enable setting. Put a tick
to enable HDCP capability on the port.
▪ Open the HDMI out 1 and 2 local output
port properties panels on the transmitter or
transceiver side and check the HDCP mode
setting.
▪ Open the HDMI out 1 and 2 output port
properties panels on the
transceiver side and check the HDCP mode
setting.

INFO: UBEX extenders always authenticate the
highest version of HDCP-encryption and cannot
force the lower version.
4.8.7. Emulate the Correct EDID
Emulate the right EDID to the HDMI input ports of the transmitter/transceiver. The EDID must be set according
to the desired resolution / refresh rate of the stream.

INFO: You can find detailed information about the EDID Management menu of the LDC software in the
EDID Management Menu section; about the technology in general please read the
section.
Navigate to the EDID Management menu in the LDC software. Select the Emulated EDIDs on the right side panel,
and select Factory EDIDs on the left side panel. See the entire list of the pre-installed factory EDIDs in the
Factory EDID List section.
receiver or
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
Example
For HDMI in 1
In our example the incoming signal on the HDMI in 1 port is 4K UHD 60 Hz (3840x2160p@60Hz 4:4:4).
Select the F137 memory address on the left side and also select the E1 EDID memory slot on the Emulated
side. Click on the Transfer button (the arrow in the middle) to emulate the selected EDID.
For HDMI in 2
In our example the HDMI in 2 port receives 1080p60 Hz signal (1920x1080p@60Hz).
Select the F48 memory track on the left side and also select the E2 EDID memory slot on the Emulated side.
Click on the Transfer button (the arrow in the middle) to emulate the selected EDID.
EDID Management

TIPS AND TRICKS:
EDID can be created via the EDID Creator wizard. See more details about it in the
EDID Creator
EDID Management menu in the LDC
If there is no pre-installed factory EDID in the list which can fit with your system, a new
section.
48 48
Creating an EDID - Easy