Transceiver Mode - F100/R100 Models - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
5. UBEX Concept 5. UBEX Concept
Description
The receiver can receive two HDMI audio streams via the SFP+ links. The streams can be selected to any
HDMI output ports, the crosspoint setting is available in the receiver as well.
Source Multiplexer (MUX)

INFO: The source MUX function can be set on the video side only in the Lightware Device Controller (LDC
software and using LW3 protocol commands as well.
The source multiplexer (Source MUX) makes available routing more different source signals to the HDMI
output ports. The type of sources is different by the two outputs.
HDMI out 1
▪ Able to accept audio signal via the SFP+ links from the remote endpoint device;
▪ Able to accept audio signal via the local HDMI in 1 port.
HDMI out 2
▪ Able to accept audio signal via the SFP+ links from the remote endpoint device;
▪ Able to accept audio signal via the local HDMI in 2 port;
▪ Able to copy the signal of the HDMI out 1 port. This is the COPY function.
HDMI Input Modes
The HDMI input ports of the receiver operate as local HDMI inputs.
Connection with an F110 Endpoint Device
When the F100/R100 receiver connects to an F110 endpoint device, the number of audio inputs expands
to three due to the analog audio input stream received via the SFP+ links. In this case the digital audio
crosspoint changes to 3x2 (3 inputs and 2 outputs).
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
5.2.3. Transceiver Mode - F100/R100 Models
Port Diagram
The port diagram is valid for the following UBEX endpoint model:
▪ UBEX-PRO20-HDMI-F100
▪ UBEX-PRO20-HDMI-R100 series
Audio port diagram of the F100/R100 transceiver in connection with an F110 endpoint
Description
The transceiver can receive an HDMI audio stream via the SFP+ links and transmitting on the HDMI out 1
port.
The transceiver receives an HDMI audio signal via the HDMI input 2 port. The audio stream is transmitted
toward the remote endpoint device over the SFP+ links.
In default state, the HDMI out 2 transmits the HDMI signal coming from the HDMI in 1 input port so it
operates as a local output port.
The HDMI input 1 port of the transceiver cannot accept audio signals due to software limitation.
Source Multiplexer (MUX)

INFO: The source MUX function can be set on the video side only in the Lightware Device Controller (LDC)
software and using LW3 protocol commands as well.
The source multiplexer (Source MUX) makes available routing more different source signals to the
HDMI output 2 port.
HDMI out 2
Able to accept audio signal via the local HDMI in 2 port;
▪
▪ Able to copy the signal of the HDMI out 1 port. This is the COPY function.
60 60