Local Hdmi Input Ports (Rx Mode); Hdmi Output Ports (Rx/Trx Modes) - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
6. Lightware Device Controller (LDC) 6. Lightware Device Controller (LDC)
6.5.9. Local HDMI Input Ports (RX Mode)
Clicking on the HDMI input 1 or 2 port icon results in opening the Port properties. The most important signal
and display information and settings are available on the panel:
Port properties window of the HDMI in 1 (RX)
Available settings and tools:
▪ Port naming;
▪ HDCP setting (Enable / Disable);
▪ Frame Detector;
▪ Reloading factory default settings for the selected port.
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
#hdcp
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
6.5.10. HDMI Output Ports (RX/TRX Modes)
Clicking on the HDMI output 1 or 2
port icon results opening the Port
properties. The most important signal
and display information and settings
are available on the panel: #hdcp
#power5v #timingmode #freerun
#sourcelocked
Available settings and tools:
▪ Port naming;
▪
HDCP mode:
– Depends on input: the
level and version of HDCP-
encryption depends on the
source device;
– Maximum possible: the
output ports set the
maximum HDCP-encryption
level which can accept by
the connected sink device.
– Forced HDCP 2.2 Type 1: the
output ports always force
HDCP 2.2 Type 1. If the sink
device supports this HDCP-encryption level, the signal will be encrypted with HDCP 2.2 Type 0/1.
The signal will be encrypted with HDCP 2.2 Type 1 when the source and the sink either support this HDCP-
encryption level.
▪ Power 5V mode (Auto / Always on / Always off);
Timing mode (Free run / Source locked).
▪

ATTENTION! When the Source locked mode setting was unsuccessful and the port uses Free run mode
as fallback, an icon appears beside the settings. It may causes that the scaler / FRC setting is not in

Pass-through mode or the resolution of the source stream is not the same that the destination stream's
one.
▪ Frame Detector;
▪ Identify Stream / Identify Display button;
▪ Reloading factory default settings for the selected port.
78 78