R-Series Endpoints - Receiver Operation Mode - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
4. Installation 4. Installation
4.4.5. R-series Endpoints - Receiver Operation Mode
2xMM-2xDUO and 2xSM-2xDUO
2xMM-QUAD and 2xSM-QUAD
2xSM-BiDi-DUO
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
Local HDMI in Connect the local source devices (e.g. PC, Blu-ray player) using the HDMI
input 1 and 2 ports by HDMI cables.
HDMI out
Connect the sink devices (e.g. monitor, projector) to the HDMI output 1 and
2 ports by HDMI cables.
Ethernet Optionally connect the receiver to a LAN in order to control the device.
Power
Connect the power adaptor to the AC input on the receiver first, then to the
AC power socket.
Connect the device and the remote UBEX endpoint by 2 pcs multimode Neutrik
OPT DUO
opticalCON DUO or 4 pcs multimode LC fiber optical cables.
OPT QUAD Connect the device and the remote UBEX endpoint by a multimode Neutrik
opticalCON QUAD fiber optical cable.
OPT DUO Connect the device and the remote UBEX endpoint by 2 pcs singlemode
Neutrik opticalCON DUO or 4 pcs singlemode LC fiber optical cables.
OPT QUAD Connect the device and the remote UBEX endpoint by a singlemode Neutrik
opticalCON QUAD fiber optical cable.
OPT BiDi DUO Connect the device and the remote UBEX endpoint by a singlemode Neutrik
opticalCON DUO BiDi or 2 pcs singlemode LC fiber optical cables. The
connector does not support the Neutrik opticalCON crossed fiber wiring
(A-A; B-B) cable. Please use standard cable (A-B) only.

WARNING! User Ethernet is also transmitted over the fiber optical interface so be sure not to create
network loop.

ATTENTION! An endpoint model can be connected to the same type of endpoint model, for example
a 2xMM-2xDUO can be connected to another 2xMM-2xDUO. Or the 2xSM-BiDi-DUO is compatible any
F-series endpoint device which is built with BiDi SFP+ modules.

INFO: The HDMI input ports can be used as local input ports only when the device is configured as receiver.
Changing the Operation Mode
The operation mode of the UBEX endpoint device can be changed using the following methods:
▪ via front panel LCD menu - see the details in the
▪ via Lightware Device Controller (LDC) software - see the details in the
▪ via LW3 protocol command - see the details in the
Operation Mode section;
Status Tab section;
Set the Operation Mode section.
41 41