Adding The Gear Oil - GAS GAS MC50 2021 Owner's Manual

16 SERVICE WORK ON THE ENGINE
16.3
92

Adding the gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
–
Remove filler plug
Gear oil
Info
Too little gear oil or poor-quality gear oil results in prema-
ture wear to the transmission.
401955-11
–
Mount and tighten filler plug
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and check for leaks.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
1
Remove screw
F03034-10
–
Remove filler plug
–
Add gear oil until it flows out of the hole of the gear oil level plug.
Gear oil (ATF Dexron 3) (
–
Mount and tighten screw
Guideline
Screw, gear oil level
monitoring
–
401955-11
Mount and tighten filler plug
2
with the O-ring, and fill up with gear oil.
0.20 l (0.21 qt.) Gear oil
(ATF Dexron 3)
( p. 109)
2
with the O-ring.
p. 91)
.
2
with the O-ring.
p. 109)
1
.
M6 6 Nm (4.4 lbf ft)
2
with the O-ring.