Adding Engine Oil - GAS GAS MC 250F 2022 Owner's Manual

17.4

Adding engine oil

Info
Too little engine oil or poor-quality engine oil will result in premature wear of the engine.
–
Lay the motorcycle on its side and fill the oil filter housing to about
⅓ full with engine oil.
–
Fill the oil filter with engine oil and position the oil filter in the hous-
ing.
–
Oil the O-ring of the oil filter cover and mount it together with oil
7
filter cover .
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
G05093-10
–
Stand the motorcycle upright.
–
Remove filler plug
Engine oil
Info
Too little engine oil or poor-quality engine oil will result in
premature wear of the engine.
–
Mount and tighten the filler plug together with the O-ring.
401955-12
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and check it for leaks.
Finishing work
–
Check the engine oil level. (
–
Remove filler plug
–
Add the same engine oil used when the last oil change was carried
out.
Engine oil (SAE 10W/50) (
Info
In order to achieve optimal engine oil performance, it is not
advisable to mix different engine oils.
GASGAS Motorcycles recommends changing the engine oil,
401955-10
if necessary.
–
Mount and tighten the filler plug together with the O-ring.
SERVICE WORK ON THE ENGINE 17
M6 10 Nm (7.4 lbf ft)
8
with the O-ring, and fill up with engine oil.
1.0 l (1.1 qt.) Engine oil (SAE
10W/50) (
p. 108)
1
with the O-ring.
p. 130)
p. 130)
111