Adding The Gear Oil - GAS GAS MC 125 2022 Owner's Manual

16 SERVICE WORK ON THE ENGINE
16.4
104

Adding the gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
Main work
–
Remove gear oil drain plug
–
Remove gear oil drain plug
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug
new seal ring.
Guideline
Gear oil drain plug with
magnet
–
Mount and tighten gear oil drain plug
Guideline
Gear oil drain plug
S04568-10
–
Remove filler plug
Gear oil
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
K00530-10
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and check it for leaks.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Park the motorcycle on a level surface.
1
with magnet.
2
.
1
with the magnet and a
M12x1.5 20 Nm (14.8 lbf ft)
2
with a new seal ring.
M10x1 15 Nm (11.1 lbf ft)
3
with the O-ring, and fill up with gear oil.
0.80 l (0.85 qt.) Engine oil (15W/50)
( p. 120)
p. 103)