16.3
Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
–
Remove filler plug
Gear oil
–
Mount and tighten filler plug
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
401955-11
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and check it for leaks.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
1
Remove screw
S04352-10
–
Remove filler plug
–
Add gear oil up to the bottom edge of the hole of the gear oil level
plug.
Engine oil (15W/50) (
–
Mount and tighten screw
Guideline
Screw, gear oil level
monitoring
401955-11
–
Mount and tighten filler plug
SERVICE WORK ON THE ENGINE 16
2
with the O-ring, and fill up with gear oil.
0.50 l (0.53 qt.)
Engine oil (15W/50)
(
2
with the O-ring.
p. 100)
with the seal ring.
2
with the O-ring.
p. 117)
1
with the seal ring.
M6
8 Nm (5.9 lbf ft)
2
with the O-ring.
p. 117)
101