Preferred Symbology Default; Character Activation Mode; Activation Character; End Character Activation After Good Read - Honeywell Solaris 7980g User Manual

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their default val-
ues.

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scan-
ning. When the activation character is received, the scanner continues scanning
until either the
deactivation character is received (see
code is transmitted. Scan the On bar code to use character activation, then use

Activation Character

host to start scanning. Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the
value that represents the character you want to use to trigger scanning. Scan the
following bar code, then use the
combination that represents that ASCII character. Scan Save to finish.

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the LED can be
programmed either to remain on and scanning, or to turn off. When End Character
Activation After Good Read is enabled, the LED turns off and stops scanning after
Solaris 7980g User Guide
Character Activation LED Timeout
(page 3-53) to select the character you will send from the
* Off
ASCII Conversion Chart (Code Page
Preferred Symbology Default
Deactivation Character
Programming Chart
Activation Character
(page 3-54) is reached, the
on page 55), or a bar
1252), page 224, find the hex
to read the alphanumeric
On
53