Character Activation; Activation Character; End Character Activation After Good Read - Honeywell Xenon XP 195 Series User Manual

Character Activation

You may use a character sent from the host to trigger the scanner to begin
scanning. When the activation character is received, the scanner continues
scanning until either the
deactivation character is received (see
barcode is transmitted. Scan the On barcode to use character activation, then use

Activation Character

to start scanning. Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the
value that represents the character you want to use to trigger scanning. Scan the
following barcode, then use the
combination that represents that ASCII character. Scan Save to finish. Default = 12
[DC2].

End Character Activation After Good Read

After a barcode is successfully detected and read from the scanner, the
illumination can be programmed either to remain on and scanning, or to turn off.
When End Character Activation After Good Read is enabled, the illumination
turns off and stops scanning after a good read. If you scan Do Not End Character
Activation After Good Read, the illumination remains on after a good read.
Activation After Good Read
Xenon XP User Guide
(page 97) to select the character you will send from the host
* Off
ASCII Conversion Chart (Code Page
Do Not End Character
Character Activation Timeout
Deactivation Character
Programming Chart
Activation Character
(page 98) is reached, the
on page 98), or a
1252), page 300, find the hex
to read the alphanumeric
On
97