Character Activation Mode; Activation Character - Honeywell Vuquest 3310g User Manual

trigger mode by setting the Hands-Free Time-Out. Once the time-out value is
reached, (if there have been no further button presses) the scanner reverts to
the original hands-free mode.
Scan the Hands-Free Time-Out bar code, then scan the time-out duration
(from 0-300,000 milliseconds) from the inside back cover, and Save. Default =
5,000 ms.

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin
scanning. When the activation character is received, the scanner continues
scanning until either the
deactivation character is received (see
or a bar code is transmitted. Scan the following On bar code to use character
activation, then use Activation Character (following) to select the character you
will send from the host to start scanning. Default = Off.
* Off

Activation Character

This sets the character used to trigger scanning when using Character Acti-
vation Mode. On the
4, find the hex value that represents the character you want to use to trig-
ger scanning. Scan the following bar code, then use the
Chart to read the alphanumeric combination that represents that ASCII
character. Scan
Hands-Free Time-Out
Character Activation Laser Timeout
ASCII Conversion Chart (Code Page
Save to finish.
Activation Character
Deactivation Character
(page 3-14), the
on page 3-15),
On
1252), page A-
Programming
3 - 13