Clutch Slave Cylinder, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 12.2014
1.11 Clutch Slave Cylinder, Removing and
Installing
Special tools and workshop equipment required
♦ Hose Clamps - Up To 25 mm - 3094-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Nuts - Transmission Support to Transmission
Removing
Note
Before replacing the clutch master cylinder due to an assumed
♦
defect, perform the
Guided Fault Finding
nostic Tester first.
If the clutch slave cylinder is removed from the transmission
♦
with the hose/line assembly connected, do not operate (de‐
press) clutch pedal any more. Otherwise, the pistons are
pushed out of the clutch slave cylinder and thus damaged.
Disconnect the battery ground cable. Refer to ⇒ Electrical Equip‐
ment; Rep. Gr. 27 ; Battery; Battery, Disconnecting and Con‐
necting .
– Remove the entire air filter housing if it makes the clutch slave
cylinder inaccessible. Refer to ⇒ Engine Mechanical, Fuel In‐
jection and Ignition; Rep. Gr. 24 ; Air Filter; Air Filter Housing,
Removing and Installing .
– Remove the transmission support -arrows-.
– Remove the battery and the battery tray if necessary. Refer to
⇒ Electrical Equipment; Rep. Gr. 27 ; Battery; Battery, Re‐
moving and Installing .
30
Rep. Gr.30 - Clutch
Vehicle Diag‐