Volkswagen Golf 2015 Repair Manual page 155

– Press the taper roller bearing outer race into the clutch housing
all the way.
– Install the outer race/tapered roller bearing all the way into the
transmission housing without the adjusting shim.
– Install the input shaft into the clutch housing and mount the
transmission housing. Install the hex bolts. Refer to
⇒ 5.4 Overview - Transmission Housing and Selector Mech‐
anism , page 95 .
– Install the measuring device and the dial gauge in the clutch
housing.
– Rotate the input shaft before measuring so the tapered roller
bearing settles. Set the dial gauge with 1 mm pretension to 0 .
Note
Repeat this process each time a measurement is taken otherwise
the dial gauge will not go back to its start setting.
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 12.2014
149
1. Input Shaft