Volkswagen Golf 2015 Repair Manual page 171

Disassembling and Assembling Locking Collar and Synchronizer
Hub for 3rd/4th Gears
1 - Spring
Allocate the correct springs. Refer to the Parts Catalog.
Assembly in conjunction with hollow locking pieces. Refer to
⇒ Fig. Assembly: Locking Collar/Synchronizer Hub for 1st and
2nd Gears Together with Locking Pieces That Are Hollow on the
Inside , page 162 .
Assembly in conjunction with locking pieces that are not hollow.
Refer to
⇒ Fig. Assembly: Locking Collar/Synchronizer Hub for 1st and
2nd Gears Together with locking Pieces That Are Not Hollow ,
page 162 .
2 - Locking piece
Allocate the locking pieces. Refer to the Parts Catalog.
3 - Locking collar
4 - Synchronizer Hub
– Slide the locking collar over the synchronizer hub.
The notches for the locking pieces on the synchronizer hub and
locking collar must line up with each other.
Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th
Gears Together with Locking Pieces that are Hollow on the Inside
The locking collar is pushed over the synchronizer hub.
– Install the locking pieces and springs offset by 120°. The an‐
gled end of the spring must engage into the hollow locking
piece.
Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th
Gears Together with Locking Pieces that are Not Hollow
• The locking collar is pushed over the synchronizer hub.
– Install the locking pieces and springs offset by 120°. The an‐
gled end of the spring must be positioned in front of the locking
pieces -arrows-.
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 12.2014
165
2. Output Shaft