Volkswagen Golf 2015 Repair Manual page 199

Spring Pin with Surrounding Groove (Short Spring Pin): Remov‐
ing and Installing
Removing
– Cover the inner race/tapered roller bearing in order to prevent
possible damage and entry of shavings.
– Remove the adapter sleeve using a chisel.
Installing
– Drive into the differential housing up to the stop.
Spring Pin Without Surrounding Groove (Long Spring Pin), Re‐
moving: Press Out the Differential Bevel Gear Axle
Spring pin is sheared off when it is removed.
– Drive remaining part of roller pin out of differential housing.
Spring Pin Without Surrounding Groove (Long Spring Pin), In‐
stalling
– Align the hole in the differential bevel gear axle to the hole in
the differential housing.
– Install the new adapter sleeve to dimension -a- = 3.0 mm using
a mandrel -1-.
• The spring pin must not come in contact with the transmission
when the differential housing is installed.
On Some Transmissions, the Thrust Washer Union Has a Ridge
-A-.
Also, the differential housing has a groove -B- all the way around
it.
– Insert thrust washer union with transmission fluid.
– Install the thrust washer union so that it fits into the groove
-B- in the differential housing.
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 12.2014
193
2. Differential