Overview - Clutch Release Mechanism - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 12.2014
13 - Clamp
❑ The clamp must be removed in order to remove/install the hose/line assembly
14 - Hex bolt
❑ Tightening specification. Refer to
1.4

Overview - Clutch Release Mechanism

1 - Transmission
2 - Ball Stud
❑ 25 Nm
❑ For removing and instal‐
ling, remove the trans‐
mission
❑ Remove grease from
extractor lever contact
surfaces
❑ Grease the contact sur‐
face on the ball stud with
Grease for Clutch Disc
Shaft Splines -
G 000 100-
3 - Input Shaft Seal
❑ Replacing. Refer to
⇒ 1.4 Input Shaft Seal,
Replacing , page 152
4 - Guide Sleeve
❑ For removing and instal‐
ling, remove the trans‐
mission
❑ With vulcanized O-ring
❑ Replace the guide
sleeve and O-ring if the
O-ring is damaged.
5 - Spring
❑ For removing and instal‐
ling, remove the trans‐
mission
❑ Attach to the clutch re‐
lease lever
6 - Cylinder Bolt
❑ 20 Nm
7 - Clutch Release Lever
❑ For removing and installing, remove the transmission
❑ Remove and install together with release bearing
⇒ Fig. Remove and Install the Clutch Release Lever with the Release Bearing , page 35
❑ Remove grease already present
❑ Grease the contact surface on the ball stud with Grease for Clutch Disc Shaft Splines - G 000 100-
8 - Release Bearing
❑ For removing and installing, remove the transmission
❑ Do not wash the bearing, just wipe it off.
❑ Replace loud bearings
18
Rep. Gr.30 - Clutch
⇒ 1.4 Overview - Clutch Release Mechanism , page 18
.
.