Volkswagen Golf 2015 Repair Manual page 33

– Remove the Data Bus on Board Diagnostic Interface - J533-
-1- from the bracket. Refer to ⇒ Electrical Equipment; Rep.
Gr. 97 ; Control Modules; Component Location Overview -
Control Modules and push it aside.
– Remove bolt -2-, unclip the crash bolster -1- and push aside.
– Remove the entire air filter housing if the clutch mechanism
lines are not accessible. Refer to ⇒ Engine Mechanical, Fuel
Injection and Ignition; Rep. Gr. 24 ; Air Filter; Air Filter Hous‐
ing, Removing and Installing .
– Remove the battery. Refer to ⇒ Electrical Equipment; Rep.
Gr. 27 ; Battery; Battery, Disconnecting and Connecting .
Caution
Danger of leaking brake fluid.
♦ Be careful not to get any brake fluid on the longitudinal
member or on the transmission when performing the fol‐
lowing work. If it does, clean the area thoroughly.
♦ Place a lint-free cloth under the clutch master cylinder.
– Unclamp the supply hose -2- to the clutch master cylinder with
a Hose Clamps - Up To 25mm - 3094- .
Note
A slight deformation of the supply hose remains after the Hose
♦
Clamps - Up To 25mm - 3094- have been unclamped.
The supply hose is therefore not defective.
♦
After removing the Hose Clamp up to 25 mm - 3094- , the
♦
supply hose must be formed back into its original shape.
– Remove clip for hose/line assembly -1- all the way and remove
hose/line assembly.
– Seal off openings.
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 12.2014
27
1. Clutch Mechanism