Volkswagen Golf 2015 Repair Manual page 34

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 12.2014
– Remove the clutch master cylinder return hose and seal with
the Sealing Tool - T10249/1- .
Note
When working inside the footwell, cover the carpet with cloths to
protect it from leaking brake fluid.
– Disconnect the connector -2- from the Clutch Position Sensor
- G476- .
– Remove nuts -arrows- and bracket -1-.
Installing
Install in reverse order of removal. Note the following:
– Replace self-locking nuts and clutch master cylinder seals af‐
ter removing them.
– Insert the crash bolster -1- and tighten the bolt -2-. Refer to ⇒
Body Interior; Rep. Gr. 70 ; Instrument Panel Central Tube;
Overview - Instrument Panel Central Tube .
– Install the Data Bus on Board Diagnostic Interface - J533- .
Refer to ⇒ Electrical Equipment; Rep. Gr. 97 ; Control Mod‐
ules; Component Location Overview - Control Modules .
– Install the driver side footwell vent. Refer to ⇒ Heating, Ven‐
tilation and Air Conditioning; Rep. Gr. 87 ; Air Routing; Driver
Side Footwell Vent, Removing and Installing .
Vehicles with a Knee Airbag
– Install the driver side knee airbag. Refer to ⇒ Body Interior;
Rep. Gr. 69 ; Knee Airbags; Overview - Knee Airbag .
Note
The battery will be installed and connected later.
Continuation for All
28
Rep. Gr.30 - Clutch