Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
1.9
Bearing Bushing, Removing and Instal‐
ling
Removing
Disconnect the battery ground cable. Refer to ⇒ Electrical Equip‐
ment; Rep. Gr. 27 ; Battery; Battery, Disconnecting and Con‐
necting .
– Press together the retainers in the direction of -arrows- and
remove the studs -1- to the right side.
– Turn the valve fitter such that the openings -1- or pin -2- are
visible.
The openings -1- and the pin -2- face in the same direction.
– Remove the bearing bushing -A- from the openings -1-.
Installing
– Turn the valve fitter such that the openings -1- or pin -2- are
visible.
The openings -1- and the pin -2- face in the same direction.
– Fit the bearing bushing -A- in the openings -1- and rotate into
place.
– Use a new mounting pin to connect the valve fitter/clutch mas‐
ter cylinder to the clutch pedal.
– Connect the battery. Refer to ⇒ Electrical Equipment; Rep.
Gr. 27 ; Battery; Battery, Disconnecting and Connecting .
1.10
Clutch Master Cylinder, Removing and
Installing
Removing
Note
Before replacing the clutch master cylinder due to an assumed
♦
defect, perform the
Guided Fault Finding
sis Tester first.
When working inside the footwell, cover the carpet with cloths
♦
to protect it from leaking brake fluid.
32
Rep. Gr.30 - Clutch
Vehicle Diagno‐