Table of Contents
Advertisement
Phaeton 2003 ➤
6-cylinder injection engine - Edition 02.2014
1.2
Removing and installing cylinder head
Special tools and workshop
equipment required
♦ Camshaft bar - T10068 A-
♦ Drip tray - V.A.G 1306-
♦ Torque wrench (5...50 Nm)
- V.A.G 1331-
♦ Torque wrench (40...200
Nm) - V.A.G 1332-
♦ Spring-type clip pliers -
VAS 5024A-
♦ Lifting tackle - 3033-
♦ Sealant - AMV 174 004 01-
♦ Sealant - D 176 501-
Removing
Prerequisites
•
Engine has been removed
•
The engine must be no more than warm to touch.
•
Coolant has been drained
Caution
When doing any repair work, especially in the engine compart‐
ment, pay attention to the following due to the cramped condi‐
tions:
♦ Route all the various lines (e.g. for fuel, hydraulics, acti‐
vated charcoal filter system, coolant, refrigerant, brake
fluid and vacuum) and electrical wiring in their original po‐
sitions.
♦ Ensure that there is sufficient clearance to all moving or
hot components.
52
Rep. gr.15 - Cylinder head, valve gear
⇒ page 3
⇒ page 115
.
Advertisement
Table of Contents
