Right Seal, Replacing - Volkswagen Golf 2015 Repair Manual

Installing
– Lightly oil new seal on outer circumference.
– Fill the space between the sealing and dust lip -arrow- halfway
with Sealing Grease - G 052 128 A1- .
– Install the seal all the way in without tilting it.
– Install the flange shaft.
– Press the flange shaft against the transmission and secure it
with the bolt.
– Attach the drive axles to the transmission. Refer to ⇒ Sus‐
pension, Wheels, Steering; Rep. Gr. 40 ; Drive Axle; Drive
Axle, Removing and Installing .
– Check the transmission fluid and fill if necessary. Refer to
⇒ 8 Transmission Fluid , page 125
– Install the lower section of the left front wheel housing liner.
Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Wheel Housing Liner;
Front Wheel Housing Liner, Removing and Installing .
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Noise Insulation; Overview - Noise Insulation .
– Install the wheel. Refer to ⇒ Suspension, Wheels, Steering;
Rep. Gr. 44 ; Wheels and Tires; Wheel Bolt Tightening Spec‐
ifications .
Tightening Specification
♦ Refer to ⇒ 2.1 Overview - Differential , page 189
1.3

Right Seal, Replacing

Special tools and workshop equipment required
♦ Seal Installer - One-Piece Seal - T10148-
♦ Spindle from the Seal Installer - Driver Set - 3066-
♦ Slide Hammer Set - VW771-
♦ Slide Hammer Set - Hook - VW771/37-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Used Oil Collection and Extraction Unit - SMN372500-
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Seal - Right Flange Shaft
♦ Bolts - CV Boot to Inner CV Joint
Manual Transmission - Edition 12.2014
.
.
Golf 2015 ➤ , Golf Variant 2015 ➤
185
1. Seals