Volkswagen Golf 2015 Repair Manual page 198

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 12.2014
Removing the Outer Race/Tapered Roller Bearing from the
Transmission Housing
A - Counter Support , for example, Puller - Kukko Counterstay -
22/2-
B - Internal Puller 46 to 58 mm , for example, Puller - Kukko In‐
ternal - 46-56mm - 21/7-
Installing the Outer Race/Tapered Roller Bearing Into the Trans‐
mission Housing.
– Install the adjusting shim under the outer race.
– Support the transmission housing with the Bearing Installer -
Wheel Bearing - 3144- directly under the bearing mount.
Differentiating the Spring Pins
Dimension a mm
28.5 (short tension sleeve),
removing and installing. Refer to
⇒ Fig. Spring Pin with Surrounding
Groove (Short Spring Pin): Remov‐
ing and Installing , page 193
36.0 (long spring pin),
removing. Refer to
⇒ Fig. Spring Pin Without Sur‐
rounding Groove (Long Spring Pin),
Removing: Press Out the Differential
Bevel Gear Axle , page 193
installing. Refer to
⇒ Fig. Spring Pin Without Sur‐
rounding Groove (Long Spring Pin),
Installing , page 193
Allocation, Differential Housing
The hole in the differential housing was modified due to the longer
spring pin.
Hole
-A-
-A- and -B-
192
Rep. Gr.39 - Final Drive, Differential
Identifying Feature
Groove all the way
around -arrows-
no surrounding groove
,
Spring Pin Length (mm)
28.5 (short spring pin)
36.0 (long spring pin)