Table of Contents
Advertisement
70/92
Maintenance and repair
10 Maintenance and repair
Delayed inspection and maintenance works!
Damage to property!
Perform the prescribed inspection and maintenance works at the intervals specified
in these instructions.
If during operation or a test, irregularities, variations, faults or wear are identified,
the following shall be observed in any case:
Take the work station out of operation without undue delay.
Determine the cause and remedy the defects. If you are not successful, inform
the Bosch Rexroth service.
Replace the defective component.
Where appropriate, do not put the WS200 work station back into operation.
Store and dispose of any supplies and auxiliary materials spilled and used pursuant to
the country-specific legal provisions.
10.1 Cleaning and care
Cleaning of components made of plastic.
With minor contamination (e.g. for dust), it is sufficient to wipe the component with
a damp cloth soaked in water.
With heavy contamination (e.g. with oil-containing residues), we recommend using
a special plastic cleaning agent.
Never use solvents or aggressive cleaning agents which might attack the plastic.
Before using any cleaning agent, obtain information about the usability and possible
dangers by referring to the user instructions on the packaging of the cleaning agent.
• Do not blow off the work station using compressed air. Sensors and valves of the
functional assemblies might be damaged.
• If you have to remove hydraulic fluid, use suitable binders and cleaning cloths.
• Store and dispose of any supplies and auxiliary materials spilled and used as
prescribed pursuant to the country-specific legal provisions.
Bosch Rexroth AG, WS200, DCA_DE_000151/10-2013
NOTICE
Advertisement
Table of Contents
Troubleshooting
