Removing And Installing Headlight Range Control Motor - Skoda Octavia III 2013 Workshop Manual

Right-hand drive:
– Forcefully press on the middle area of the foil -B-.
– Carefully pull off the auxiliary part of the foil -A- from the head‐
light.
Only a part of the protective foil remains on the lens -B-.
Note
Inform the customer about the corresponding notes for removing
the residual glue after pulling off the protective foil, e.g. textiles
soaked in isopropyl alcohol (do not use any aggressive solvent,
which can damage the polycarbonate lenses).
1.7 Removing and installing headlight range
control motor
Removing
– Remove the headlight from which the control motor is removed
⇒ "1.2 Removing and installing headlight", page 80
– Remove cover -2-.
The headlight on the left:
– Carefully knock out and remove the plug -2-.
– Release securing bolts underneath the plugs.
Note
The bolts beneath the plugs are not exactly in the opening axle -
for this reason, the control motor -1- needs to be swivelled out a
little -arrow-.
The headlight on the right:
– Carefully knock out and remove the plug -3-.
– Undo the screw underneath the plug and the bolt -2-.
Note
The bolt beneath the plug are not exactly in the opening axle - for
this reason, the control motor -1- needs to be swivelled out a little
-arrow-. To release the bolt -2- use a flexible approach, using a
smaller Torx where necessary.
Both headlights:
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
.
1. Headlights – halogen headlights
85