Skoda Octavia III 2013 Workshop Manual page 19

– 1.8 TSI engine – Loosen hose clamps -2-, unscrew screws
-arrows- and remove air flow hose.
Note
Close open lines with clean plug for example from the blanking
plug set -VAS 6122- .
– For 1.2 TSI engine remove guide roller, and for 1.4 TSI remove
deflection roller ⇒ Engine; Rep. gr. 13 .
All vehicles:
– Remove the screen cap from the fixing nut of the B+ cable
-1- and unscrew the nut.
– Unplug connector -2-.
– Unscrew the securing nut (3.2 Nm) for line holder -3- or unclip
the line (engine-dependent), and lay the line to the side.
– Vehicles with AC generator secured from the front side – screw
out screws -arrows- (23 Nm).
Note
If the AC generator is jammed in the holder, screw the screws
♦
back in, then loosen them in two turns.
Tap the screw heads gently with the flat side of the hammer.
♦
This will loosen the bushings that are used for securing the AC
generator.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
11
4. Generator