Skoda Octavia III 2013 Workshop Manual page 77

– Unscrew the nuts -2- by a few turns.
– Push the extractor for wiper arms -T10369/1- , as shown, onto
the arm.
Note
To release the wiper arm, always use the thrust piece -2- in order
to avoid damage to the thread of the wiper motor shaft.
– Release the wiper arm -1- from the shaft by turning the pres‐
sure screw -3-.
– Unscrew nuts and remove arms.
Installing
Note
When switching off for the second time, the wiper motor over‐
♦
runs in the offset final setting so that the wiper blade lip is
controlled in the other direction.
The wiper motor runs downwards and then again a little up‐
♦
wards. This offset final setting cannot be used to compensate
for the windscreen wiper crank.
The final setting must be used in which the wiper motor runs
♦
directly and without overrun in the lower final setting. If the
wiper motor runs in the offset final setting, wiping must be
switched on again.
Function of the offset final setting is active only after 100 wiper
♦
cycles as of coding or installation of a new wiper motor. If this
function is already activated, it can be determined by switching
on and off the wiper motor repeatedly.
– Switch wiper motor on and off and run until it is in park position
for setting the windscreen wiper arms.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
3. Windscreen wiper and washer system
69