Generator; Checking Generator; Removing And Installing Alternator - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
4

Generator

⇒ "4.1 Checking generator", page 10
⇒ "4.2 Removing and installing alternator", page 10
⇒ "4.3 Fixing the B+ wire to the AC generator", page 12
⇒ "4.4 Checking the carbon brushes of the AC generator",
page 13
⇒ "4.5 Removing and installing the Bosch voltage regulator", page
13
⇒ "4.6 Removing and installing the Valeo voltage regulator", page
14
⇒ "4.7 Removing and installing the V-ribbed belt pulley on the AC
generator", page 14
⇒ "4.8 Removing and installing the V-ribbed belt pulley with free
wheel", page 15
4.1

Checking generator

The AC generator can be inspected with the ⇒ Vehicle diagnostic
tester in the function "Targeted fault finding" point - body / elec-
trical system / 27-starter, voltage supply / electrical components /
AC generator - C- .
4.2

Removing and installing alternator

Removing
- Disconnect battery earth strap
⇒ "2.3 Work sequence when disconnecting and connecting
the battery", page 2 .
- Remove the V-ribbed belt ⇒ engine; Rep. gr. 13 .
Vehicles with TDI engine
- Remove the fuel filter ⇒ Engine; Rep. gr. 20 and lay it to the
side (do not detach hoses).
Vehicles with TDI and 1.2/1.4/1.8 TSI engines:
- Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
- Remove fan shroud with cooling fans ⇒ Engine; Rep. gr. 19 .
- Remove AC compressor (do not open the refrigerant circuit)
and secure to the side so that the intake hoses are not exces-
sively strained ⇒ Heating, Air Conditioning; Rep. gr. 87 .
10
Rep. gr.27 - Starter, current supply, CCS