Removing And Installing The Clearance Control Control Unit J428; Removing And Installing Retaining Plate For Clearance Control Control Unit J428 - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
7.3 Removing and installing the clearance
control control unit - J428-
Note
When replacing the Clearance control control unit - J428- , con‐
nect ⇒ Vehicle diagnostic tester and, in the operating mode
"Targeted fault finding" or "Targeted functions" ,select the function
"Replace relevant control unit".
Removing
– Switch off the ignition and all electrical components.
– Remove front bumper ⇒ Body Work; Rep. gr. 63 .
– Unscrew screws -3- (8 Nm) and remove control unit -1- with
retaining plate.
– Where necessary, remove locking lugs -arrows A-, tilt out con‐
trol unit -1- -arrow B- and push out from the holder -3-.
– Separate plug connection -2-.
Install
Installation is performed in the reverse order, pay attention to the
following points:
– Calibrate automatic distance control
⇒ "7.5 Calibrate automatic distance control", page 23
7.4 Removing and installing retaining plate
for clearance control control unit - J428-
Removing
– Removing steering column electronics control unit - J428-
⇒ "7.3 Removing and installing the clearance control control
unit J428 ", page 22 .
22
Rep. gr.27 - Starter, current supply, CCS
.