Headlight Cleaning System; Replacing The Windscreen Wiper Blades - Skoda Yeti Owner's Manual

Skoda car
Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

Headlight cleaning system

ä
First read and observe the introductory information and safety warn-
ings
on page 53.
The headlights are being cleaned after the windscreen has been sprayed for the
first time and fifth time, the low beam or main beam are switched on and the
windscreen wiper lever was held in the position
The headlight washer nozzles are moved forward out of the bumper by the water
pressure for cleaning the headlights.
You should remove stubborn dirt (such as insect residues) from the headlight len-
ses at regular intervals, for example when refuelling. The following guidelines
must be observed
» page
169, Headlight lenses.
To ensure the proper operation of the cleaning system during the winter, any
snow should be removed from the washer nozzle fixtures and ice should be
cleared with a de-icing spray.
CAUTION
Never remove the nozzles from the headlight cleaning system by hand - risk of
damage!

Replacing the windscreen wiper blades

ä
First read and observe the introductory information and safety warn-
ings
on page 53.
When in the rest position, the wiper arms cannot be fold down from the wind-
screen. Before replacing, the wiper arms must be placed in the service position.
56
Using the system
» Fig. 36
for about 1 second.
5
Fig. 37
Windscreen wiper blade
Service position for changing wiper blades
Closing the bonnet.
Switch the ignition off and on again.
Then press the windscreen wiper lever into position
onds – the wiper arms move into the service position.
Removing the wiper blade
Fold the windscreen wiper arm away from the windscreen.
Press the locking button
1
the direction of the arrow
2
Attaching the wiper blade
Push the windscreen wiper blade until the stop and it locks in place.
Check whether the wiper blade is correctly attached.
Fold the wiper arms back to the windscreen.
The windscreen wiper arms move back into the rest position - after switching on
the ignition and changing the position of the window wiper lever or when driving
at a speed of more than 6°km/h.
Windshield wiper blades in proper condition are essential to obtain good visibility.
Wiper blades should not be allowed to become dirtied by dust, insect remains and
preserving wax.
Juddering or smearing of the wiper blades could then be due to wax residues left
on the windshield by vehicle washing in automatic vehicle wash systems. It is
therefore important to degrease the lips of the windshield wiper blades after ev-
ery pass through an automatic vehicle wash system.
» Fig. 36
4
» Fig. 37
to unlock the wiper blade and pull off in
.
within 10 sec-

Advertisement

Table of Contents
loading

Table of Contents