Automatic Rear Window Wiper; Alternative Park Position Of The Rear Window Wiper; Headlight Cleaning System - Skoda Yeti Owner's Manual

Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

This rest position is set as follows:
Switch on the windscreen wipers.
Switch off the ignition. The windscreen wipers remain in the position in which
they were when switching off the ignition.
The service position can also be used as a winter position

Automatic rear window wiper

First read and observe the introductory information and safety warn-
ings
on page 51.
If the windscreen wiper is in position
dow is wiped every 30 or 10 seconds if the vehicle's speed exceeds 5 km/h.
When the rain sensor is active (the lever is in the position
active if the windscreen wipers operate in continuous mode (no break between
each wiping process).
Activation/deactivation
The function of the automatic rear window wiper is activated/deactivated in the
information display in the menu:
Settings
Lights and visibility

Alternative park position of the rear window wiper

First read and observe the introductory information and safety warn-
ings
on page 51.
Each time after switching off the engine for the second time, the wiper blade of
the rear window wiper is tilted. This prolongs the life of the wiper blade.
Activation/deactivation
Switch on the ignition.
Push the operating level into the position
succession within 5 seconds.
Switch off the ignition. After switching on the ignition again, the alternative
park position of the rear window wiper is activated/deactivated.
» page
54.
» Fig. 37
on page 52 or
the rear win-
2
3
) the function is only
1
» Fig. 37
on page 52 five times in
6

Headlight cleaning system

First read and observe the introductory information and safety warn-
ings
on page 51.
The headlights are being cleaned after the windscreen has been sprayed for the
first time and fifth time, the low beam or main beam are switched on and the
windscreen wiper lever was held in the position
1 second.
The headlight washer nozzles are moved forward out of the bumper by the water
pressure for cleaning the headlights.
You should remove stubborn dirt (such as insect residues) from the headlight len-
ses at regular intervals, for example when refuelling. The following guidelines
must be observed
» page
183, Headlight lenses.
To ensure the proper operation of the cleaning system during the winter, any
snow should be removed from the washer nozzle fixtures and ice should be
cleared with a de-icing spray.
CAUTION
Never remove the nozzles from the headlight cleaning system by hand - risk of
damage!
» Fig. 37
on page 52 for about
5
53
Lights and visibility

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents