Image Control - EverFocus H.265 VANGUARD II Series User Manual

4.1.3

Image Control

You can configure the image settings for supported IP cameras.
Channel: Displays the channel number.
Setup: Click to enter the setup page. You can use the left-side panel to adjust the
parameters. The system will automatically save the settings.
Channel: Select a channel number.
Day/Night Mode: Select a Day/Night mode for the
camera to display the color or B/W images.
• GPIO Auto: Select GPIO Auto for the camera to
automatically switch to day or night mode. You can
further set up a Delay Switch time (second) in the
below field.
• Color Mode: Select Color Mode for the camera to
display color images.
• Black White Mode: Select Black White Mode for the
camera to display B/W images.
• Schedule (B/W): Select Schedule (B/W) for the
camera to display B/W images during the setup time
range. Please select the Start Time and End Time in
the below field.
Delay Switch (s): This function can only be activated if
you select Auto for the Day/Night Mode. Set up a delay
switch time (seconds) for the camera to auto switch
between day and night modes.
IR-LED: Select On to turn on IR LEDs; select Off to turn
off IR-LED; select Auto for the camera to automatically
turn on / off the IR-LED based on the light sensor on the
IP camera.
Flip: Check the box to enable the Flip function. The
image will be rotated vertically around a horizontal axis.
34
H.265 VANGUARD II Series