EverFocus H.265 VANGUARD II Series User Manual page 129

H.265 VANGUARD II Series
Transparency: Slide the bar to the left or right to adjust the transparency for the OSD Setup
menu.
Default: Click to apply the default setting.
Apply: Click to save the settings.
Call Monitor Setting
Video Output: Select Call Monitor Output and then configure the below settings.
CVBS Call Monitor: Check the box to enable the Call Monitor function.
Sequence Mode: Select Enable to enable sequence mode or Disable to disable sequence
mode.
Sequence Layout: This function only appears when Enable is selected from the Sequence
Mode field. Select a layout for the sequence mode. For example, if you select Layout4, the
DVR will display a quad view layout for all channels in sequence order. To start the sequence
mode, go to OSD menu > Layout and then click the Auto Sequence button. Click the button
again to stop sequence mode.
Sequence Interval Time: This function only appears when Enable is selected from the
Sequence Mode field. Select a sequence dwell time in second. By default, 5 seconds is set up.
Click Sequence Settings to enable the sequence mode for the selected channels.
Layout Mode: This function only appears when Disable is selected from the Sequence Mode
field. You can configure the layout mode for the Call Monitor. Select a layout from the drop-
down list and then click Layout Settings to assign channels to the layout.
Full Screen: Check the box to enable Full Screen of the triggered channel.
Default: Click to apply the default setting.
Apply: Click to save the settings.
123