Ptz - EverFocus H.265 VANGUARD II Series User Manual

4.1.4

PTZ

Please connect the PTZ cameras to the DVR and then configure the below PTZ settings. After
configuring the PTZ settings, you can start using the PTZ Control panel to control the PTZ
camera. Please refer to 3.5.2.1 PTZ Control.
Channel: Displays the channel number.
Signal Type: Analog for analog channels; Analog /Digital for IP channels.
Protocol: Select a communication protocol between the PTZ camera and DVR. If your camera
supports the UTC function, select UTC1 or UTC2. For more details on UTC function, please
refer to 3.5.2.3 UTC Control.
Note: For EverFocus' PTZ cameras, only the UTC-enabled PTZ cameras support the UTC
function.
Baudrate: This field is to set the speed at which is used to transmit instruction or information
from the DVR to the PTZ camera.
Data Bit / Stop Bit: The information between the DVR and PTZ camera is sent in individual
packages. The Data Bit indicates the number of bits sent, while the End Bit indicates the end
of the package and the beginning of the next (information) package.
Parity: For error check. Refer to the documentation of your PTZ camera to configure this
setting.
Address: Input the ID address of the PTZ camera. Note this address should match the one set
up on the PTZ camera.
Copy: You can apply the same configurations from one channel to other channels. To perform
the Copy function:
1. Click the Copy button, the Parameter Copy window appears.
2. Select a channel from the Source Channel drop-down list and then select the
parameters you would like to apply to other channels.
3. Select the desired channels from the Target Channel field.
4. Click the Copy button, the selected channels will be applied with the same parameters
as the source channel.
Click Apply to save the settings or Default to apply the default setting.
36
H.265 VANGUARD II Series