Ip Filter - EverFocus H.265 VANGUARD II Series User Manual

4.4.5

IP Filter

You can configure the IP Filter settings on this page. This function allows you to allow or deny
some specific IP address to access the Web interface of the DVR. By default, all IP addresses
are allowed.
To set up IP Filter:
1. Check the Enable box and then select either one from the two options below. You can only
activate one option for the DVR.
Enable Whitelist: Enable the whitelist configured below.
Enable Blacklist: Enable the blacklist configured below.
2. Edit the Whitelist or Blacklist.
a. If you want to edit whitelist, select Whitelist from the Restricted Type drop-down box;
if you want to edit blacklist, select Blacklist from the Restricted Type drop-down box.
b. To add a single IP address to the list, input an IP address in the Start IP Address input
box and then click the Single Add button, the IP address will be added.
c. To add a range of IP addresses to the list, input the start IP address in the Start IP
Address input box and the end IP address in the End IP Address input box, and then
click the Network Segment Add button, the range of IP addresses will be added.
d. You can click the Edit icon
delete the IP address from the list.
3. Click the Apply button to save the settings.
to edit the IP address, or click the Delete icon
86
H.265 VANGUARD II Series
to