Configuring Cross-Counting Detection Line - EverFocus H.265 VANGUARD II Series User Manual

4.1.8.6.1 Configuring Cross-Counting Detection Line

Click the Setup button to enter the Line setup page.
1. Select a channel to configure the function.
2. Select 1 from the Rule Number drop-down list to configure the line.
3. Click the Rule Switch button to enable this rule.
4. Select a Rule Type:
AB: Detects movement from A to B.
BA: Detects movement from B to A.
5. To draw a line:
a. Use your mouse to click 2 points to draw a line.
b. If you want to move the line to other position or re-draw the line, select the line by
checking the red box on the upper-side of the line, the line will change to red color.
Drag and drop the line to a desired position. Drag the red dots of the line can re-size
the line.
c. Click the Save button to save the settings.
d. You can click the Remove All button to remove all the lines. To remove a certain line,
select the line by checking the red box on the upper-side of the line, and then click
the Remove button.
Note: The configured line should not be too short in order to enhance the detection
rate.
6. To return to the Line Crossing setup page, right-click the mouse.
1
53
H.265 VANGUARD II Series