Table of Contents
Advertisement
These CLI commands are used in a variety of situations. Any commands which require Ethernet are not
available for ATTO FibreBridge 1180 models. Refer to the
determine which CLI commands apply to your model.
Help
Displays a list of available commands. If command name
is specified, displays detailed command-specific
information.
Immediate: Help [command name]
Menu
Turns the menu interface on or off. If the interface is on,
other parameters such as ECHO will also be enabled.
Immediate: menu
RestoreConfiguration
Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option will undo any changes made since the
last save.
Immediate: RestoreConfiguration [Default | Saved]
SaveConfiguration
Many commands require a SaveConfiguration
command to be executed. This will be indicated by the
return Ready. *. When you invoke a
45
ATTO Technology Inc. FibreBridge Installation and Operation Manual
2.5.2 General use commands
CLI summary reference
SaveConfiguration command, the current
configuration is permanently saved in the FibreBridge
and the new configuration becomes the active
configuration. If a firmware restart is required to make
the requested change permanent, you are asked to
confirm the restart. You can override this request by
indicating the override value on the command line. You
may make several changes through commands before
implementing the restart, but once you have restarted the
FibreBridge, all the command changes created before the
restart and save will be implemented. If you select the
restart option, the FibreBridge will execute its complete
start up cycle.
Immediate: SaveConfiguration <Restart | NoRestart>
VerboseMode
Specifies the detail of feedback for the command line
interface. Disabling this option removes parameter
names from action commands and removes descriptions
from information commands.
Default: enabled (returns have parameter information)
Set syntax: set VerboseMode [enabled | disabled]
Get syntax: get VerboseMode
on page 41 to
Advertisement
Table of Contents
