Table of Contents
Advertisement
Installation instructions
1
Mount the FibreBridge in your device.
2
Connect a SCSI device to the
FibreBridge. Connect the Fibre
Channel port to your SAN.Connect the
Ethernet cable from the Fibre Bridge to
your computer. Refer to
page 3.
3
Connect the power connector.
4
Apply power.
5
Access FibreBridge Services using the
QuickNAV utility. Refer to
the FibreBridge
on page 64.
6
Go to the ExpressNAV Restart page
and restart the FibreBridge.
7
Map your devices.Refer to
page 67.
8
Boot the computers on the SAN and
check the configuration. Refer to
Additional configurations
mounting hole
Cabling
on
Configuring
Mapping
on
on page 17.
mounting hole
mounting hole
mounting hole
Installation: FibreBridge 1180E
12
Advertisement
Table of Contents
